Subgun/PCC Mag Pouch
Our Subgun/PCC Mag Pouch fits most 9mm-.45ACP submachinegun magazines including HK MP5 and UMP, Colt SMG, UZI, Beretta, S&W, Glock 18 machinepistol/33-rd. and other extended Glock-pattern magazines such as Magpul, and most similar magazines up to and including the 1928-M1A1 Thompson. Fits smooth-sided magazines only. Also works very well for double-column extended capacity pistol mags, including Glock, Beretta, Sig, Browning, etc.
Does NOT fit magazines with reinforcing bands around the top, sharp protrusions which extend out the sides or shoulders to prevent over-insertion in the weapon. Mags are meant to be inserted feed-lips down with no protective caps in place.
The pouch is constructed as a rugged sandwich consisting of an internal polymer stiffening layer for pressure retention, a thin layer of closed cell foam facing inward for molded retention to the specific contours of the magazine, and covered by a layer of robust 1000d Cordura nylon. This creates a friction-fit mag pouch allowing immediate access to the magazine without the need of a retaining strap.
Easy-on and easy-off with our signature wraparound belt loop, but totally secure and tough as nails. The vertical model is ambidextrous and goes anywhere for either hand. The horizontal model is designed to fit behind the hip or in the small of the back butting up against a belt loop to prevent it being pulled forward. Fits up to 1-3/4" width belts.
Fast access due to the strapless friction fit, quick-detachability and good concealability make these single pouches especially suitable for varying conditions when you may want to carry more or fewer magazines. They are especially suitable for executive protection details requiring heavier weapons than pistols, but needing a low-profile way of carrying subgun, carbine or extended pistol mags.